Editing Talk:2740: Square Packing
Please sign your posts with ~~~~ |
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 6: | Line 6: | ||
Welcome to the Hydraulic Press Channel. Today we have a set of squares that are usually used in packing problems. You are supposed to fit them into other squares by arranging them. But I think we can get them to fit easier if we put them on the press, and just try to make them smaller. We are going to start with one square, and see how much smaller we can make this. And here we go. | Welcome to the Hydraulic Press Channel. Today we have a set of squares that are usually used in packing problems. You are supposed to fit them into other squares by arranging them. But I think we can get them to fit easier if we put them on the press, and just try to make them smaller. We are going to start with one square, and see how much smaller we can make this. And here we go. | ||
− | |||
− | |||
The post where I saw this said: “God is dead, and what killed him was learning [the similarly inelegant-appearing n=17 solution].” [[Special:Contributions/172.70.254.216|172.70.254.216]] 13:08, 21 February 2023 (UTC) | The post where I saw this said: “God is dead, and what killed him was learning [the similarly inelegant-appearing n=17 solution].” [[Special:Contributions/172.70.254.216|172.70.254.216]] 13:08, 21 February 2023 (UTC) |